Hitachi C 10FCH Technical Data And Service Manual page 20

Cutting method of crown molding without tilting the saw blade
Crown molding
vise ass'y
(optional
accessory)
6 mm wing
bolt
Crown molding stopper (L)
6 mm wing bolt
(optional accessory)
Fig. 22
Crown molding vise ass'y
(optional accessory)
6 mm knob bolt
Fence
Crown molding
6 mm wing bolt
Fig. 23
After adjusting the height, firmly tighten the 6 mm wing bolt; then turn the upper knob, as necessary, to
securely attach the crown molding in position. (See Fig. 23.)
WARNING: Always firmly clamp or vise to secure the crown molding to the fence; otherwise the crown
molding might be thrust from the table and cause bodily harm. Do not perform bevel cutting.
The main body or saw blade may contact the sub fence, resulting in an injury.
CAUTION: Always confirm that the motor head does not contact the crown molding vise ass'y when it is
lowered for cutting. If there is any danger that it may do so, loosen the 6 mm knob bolt and
move the crown molding vise ass'y to a position where it will not contact the saw blade.
Position crown molding with its WALL CONTACT EDGE against the guide fence and its CEILING CONTACT
EDGE against crown molding stoppers as shown in Fig. 23. Adjust the crown molding stoppers according to
the size of the crown molding. Tighten the 6 mm wing bolt to secure the crown molding stoppers.
Crown molding stopper (R)
(optional accessory)
6 mm wing
bolt
Knob
Crown molding stopper (L)
Crown molding stopper (R)
(optional accessories)
(1) Crown molding stopper (L) and (R) (optional
accessories) allow easier cuts of crown molding without
tilting the saw blade. Install them to both sides of the
base as shown in Fig. 22. After inserting, tighten the
6 mm knob bolts to secure the crown molding guides.
[ Optional accessories used ]
Crown molding vise ass'y
(include crown molding stopper (L))
Crown molding stopper (L)
Crown molding stopper (R)
(2) The crown molding vise ass'y (optional accessory) can
be mounted on either the left fence (fence (B)) or the
right fence (fence (A)). It can unite with the slope of the
crown molding and vise can be pressed down. Then
turn the upper knob, as necessary, to securely attach
the crown molding in position. To raise or lower the vise
assembly, first loosen the 6 mm knob bolt.
--- 16 ---