1. Manuals
  2. Brands
  3. Jensen Manuals
  4. Car Receiver
  5. JCD3010
  6. Installation and operation manual

Jensen JCD3010 Installation And Operation Manual

Mobile cd player / receiver
Hide thumbs
Table of Contents

Advertisement

Quick Links

JCD3010
MOBILE CD PLAYER / RECEIVER
Installation and Operation Manual
JCD3010

Advertisement

Table of Contents
loading

Related Manuals for Jensen JCD3010

Summary of Contents for Jensen JCD3010

  • Page 1 JCD3010 MOBILE CD PLAYER / RECEIVER Installation and Operation Manual JCD3010...

  • Page 2: Safety Information

    NOTE: A disc may become scratched (although not enough to make it unusable) depending on how you handle it and other conditions in the usage environment. These scratches are not an indication of a problem with the player. JCD3010 Diameter/ Playback Time...

  • Page 3: Installation

    JCD3010 INSTALLATION Before You Begin Disconnect Battery Before you begin, always disconnect the battery negative terminal. Remove Transport Screws Important Notes • Before final installation, test the wiring connections to make sure the unit is connected properly and the system works.
  • Page 4 Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected. GROUND Connect to ground terminal or clean, unpainted metal part of chassis. JCD3010 A- A SHOWN FROM PIN VIEW...

  • Page 5: Basic Operation

    JCD3010 BASIC OPERATION Power On/Off ( ) Press the button (1) to turn the unit ON or OFF. Volume Control To increase the volume, turn the AUDIO control (4) clockwise. To decrease the volume, turn the AUDIO control counter-clockwise. If using the remote control, press the VOL /\ or VOL \/ button (24) to adjust the volume.

  • Page 6: Tuner Operation

    Select a band (if needed), then select a station. Hold a preset button (9-14) for three seconds. The preset number will appear in the display. Recall a Station Select a band (if needed). Press a preset button (9-14) to select the corresponding stored station. JCD3010 JCD3010...

  • Page 7: Controlling Disc Playback

    JCD3010 Automatically Store / Preset Scan (AS/PS, AMS) Automatically Store Select a band (if needed). Press the AS/PS button (16) on the control panel (or the AMS button on the remote control) for more than three seconds to automatically select six strong stations and store them in the current band.

  • Page 8: Specifications

    The signals are too weak ERROR 1 Mechanism Error ERROR 2 Servo Error JCD3010 Solution If the power supply is properly connected to the vehicle acces- sory terminal, switch the ignition key to “ACC”. Replace the fuse. Remove the disc in the player and insert the new one.
  • Page 9 JCD3010...
  • Page 10 ASA Electronics Corporation www.asaelectronics.com www.jensenrvdirect.com © 2010 ASA Electronics Corporation v. 092209...

Table of Contents