Hitachi DH 38MS Technical Data And Service Manual page 17

(c) Cylinder [19] and Retainer Sleeve [12]
Mount the Retainer Damper Washer [11] and Retainer Damper [10] to the Retainer Sleeve [12] in this
order by aligning the rounded portion of the Retainer Damper Washer [11] with the rounded portion of the
Retainer Sleeve [12]. Mount the Second Hammer [15] (with O-ring (C) [14] mounted), Damper Washer
[16], Damper [17] and Damper Holder [18] in this order by aligning the rounded portion of the Damper
Washer [16] with the rounded portion of the Second Hammer [15]. Insert the assembly of the Retainer
Sleeve [12] into the Cylinder Case [7], and then insert Spring Holder (B) [20] into the Cylinder Case [7].
Insert the Striker [27] (with the O-ring [28] mounted) into the Cylinder [19]. Mount the Clutch Spring [23],
Clutch [24], Bevel Gear [25] and Thrust Washer [26] to the Cylinder [19], and then insert this Cylinder [19]
ass'y into the Crank Case [70]. Insert the Lock Sleeve [22] into the Crank Case [70] by aligning the spline
groove at the inner circumference of the Crank Case [70] with the spline of the Lock Sleeve [22]. Put the
Lock Spring [21] on the Lock Sleeve [22]. Finally put the Cylinder Case [7] (with the Retainer Sleeve [12]
mounted) and the Crank Case [70] (with the Cylinder [19] mounted) together by meshing the claw of the
Retainer Sleeve [12] with the groove of the Cylinder [19] (Fig. 6).
Fig. 6
Damper Holder [18]
Damper Washer [16]
Spring Holder (B) [20]
Cylinder Case [7]
Damper [17]
Second Hammer [15]
Retainer Sleeve [12]
Bevel Gear [25]
Retainer Damper [10]
Clutch Spring [23]
Thrust Washer [26]
Retainer Damper Washer [11]
Clutch [24]
Lock Sleeve [22]
Striker [27]
Cylinder [19]
Lock Spring [21]
Crank Case [70]
(d) Slip Clutch
Refer to the Technical Data and Service Manual for the Model DH 40MR (List No. E467) because the slip
clutch mechanism is the same as that of the Model DH 40MR.
-14-