Recording Stills - Hitachi DZ-HS303SW Instruction Manual

Recording Stills

:
Note
Recording of still images is possible on card.
CARD ACCESS indicator
1
Remove the lens cap, and then point the DVD
video camera/recorder at subject.
2
Turn the DVD camera/recorder on.
Set the power switch to "SD".
After the CARD ACCESS indicator goes out,
perform the subsequent operation:
3
Check the subject on the screen (viewfinder
or LCD).
When using the viewfinder, pull it out and
close the LCD monitor.
4
Press the PHOTO/SELECT button half way
(half pressing).
The DVD video camera/recorder will
automatically focus on the subject at the
centre of screen, and the "
screen will light in purple (the focus will not
change when manual focus is chosen).
5
Press the PHOTO/SELECT button all the way
(full pressing).
The screen will be black, and then the
PHOTO/SELECT
recorded still will be displayed. When the
button
"
the next recording; while "CARD ACCESS" is
being displayed, you cannot proceed with the
next recording.
:
Note
• If you wish to record without locating a subject at the
centre of screen, first locate the subject at the centre
of screen, press the PHOTO/SELECT button halfway
down, determine the composition to be recorded, and
then press the PHOTO/SELECT button all the way
down.
• If you press the PHOTO/SELECT button all the way
down at one stroke without pressing it half way,
recording will be possible, but the focus may be
incorrect.
• See "Size And Quality Of Photos" on page 156 for
details of photos on card.
• See "Troubleshooting" on page 145 if recording
photos is not possible.
• If focusing is difficult with auto focus, choose manual
focus, and manually correct the focus before
recording (see page 54).
• Shake of the DVD video camera/recorder may cause
blur in recorded image.
• When holding the DVD video camera/recorder for
recording, grasp it securely with both hands.
• When recording with higher zoom magnification, it is
recommended that you secure the DVD video
camera/recorder on a tripod.
• There may be a difference between the image you
see on the LCD screen or viewfinder and the
recorded image.
" indicator on
" mark appears, you can proceed with
43