Special Programming - Panasonic KX-TG7731C Operating Instructions Manual

Special programming

Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each
handset.
Important:
R Set the date and time beforehand
(page 17).
1
MMENUN#720
2
MbN: Select the desired alarm option. a
MSELECTN
Off Turns alarm off. Go to step 7.
Once
An alarm sounds once at the
set time.
Daily An alarm sounds daily at the
set time. Go to step 4.
3
Enter the desired month and date. a
MOKN
4
Set the desired time.
5
MAM/PMN: Select "AM" or "PM". a MOKN
6
MbN: Select the desired alarm tone. a
MSELECTN
R We recommend selecting a different
ringer tone from the one used for
outside calls.
7
MSELECTN a MOFFN
R When the alarm is set,
Note:
R To stop the alarm, press MOFFN or place
the handset on the base unit or charger.
R When the handset is in use, the alarm will
not sound until the handset is in standby
mode.
Night mode
Night mode allows you to select a period of
time during which the handset will not ring for
outside calls. This feature is useful for time
periods when you do not want to be disturbed,
TG7731_41C_(en-en)_1207_ver.021.41
for example, while sleeping. Night mode can
be set for each handset.
Important:
R Set the date and time beforehand
(page 17).
R We recommend turning the base unit ringer
off (page 36, 38) in addition to turning the
night mode on.
R If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
1
MMENUN#238
2
MbN: Select the desired setting. a
MSAVEN
R If you select "Off", press MOFFN to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
4
MAM/PMN: Select "AM" or "PM". a MOKN
5
Enter the desired hour and minute you
wish to end this feature.
6
MAM/PMN: Select "AM" or "PM".
7
MSAVEN a MOFFN
R When the night mode is set,
displayed.
Changing the start and end time
1
MMENUN#237
2
Continue from step 3, "Turning night
mode on/off", page 41.
is displayed.
Changing the handset name
Each handset can be given a customized
name ("Bob", "Kitchen", etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is "No". If you select
"Yes" without entering any handset name,
"Handset 1" to "Handset 6" is displayed.
1
MMENUN#104
41
Programming
2011/12/07 19:54:00
is
41