Cisco CTC TV Manual

Your CTC | TV service offers many new features and capabilities.
Enjoy your viewing experience and discover the functionality of your
Remote Control and CTC | DVR service with help from this guide.
Programing your remote control for your TV:
1. Make sure your TV is turned on.
2. Press and hold the TV Button
on your remote.
3. Release both keys and the mode key will flash twice
4. Enter the following code ______________
using the number keys on your remote.
The mode key will flash three times to indicate that the code was accepted.
5. Point the remote at the TV and press POWER.
6. Did the TV turn off?
If yes, now your remote is programmed to control your TV.
If no, repeat this procedure from Step 2.
Rebooting the Cisco Set Top Box:
Reach to the back of your set top box and pull the black
power cord out for one minute to allow all memory to
drain. After one minute plug the cord back in. It is normal
for the set top box to take up to 10 minutes to reboot.
Default PIN: For access to menu options such as
Parental Controls, the Default PIN # is: 0000
Identifying your set-top box cables
Ethernet HDMI
Cisco

Troubleshooting Tips

and the OK Button
Component S Video
Remote Control Guide
Automatic TV Code Search:
1.Turn on the TV that you want to program your remote to.
2. Point the remote at your TV. Press and hold the
and the OK Button at the same time.
3. Release both keys and all the
4. Enter the programming code 922
number keys on the remote.The
twice indicating a successful entry.
5. Point the remote toward the TV, and press and hold
PLAY.The remote will automatically start testing codes.
6. Keep holding down the PLAY Button
When a code is found that works your TV will shut off.
7. Release the PLAY Button.
8. Save the code by pressing the
remote.The mode keys will flash three times indicating
successful entry.
Note: Pressing the rewind button allows you to go
back if you missed your code or you hold down the
play button too long after your TV shuts off.
RCA Cable
TV Button
mode keys will blink twice.
by pressing the
TV Button will blink
and watch your TV.
ENTER Button on the
Coax Power