Makita HM0810B Instruction Manual page 5

Installing or removing bull point or other bits (cold chisel, etc.)
CAUTION
:
Always be sure that the tool is switched off and unplugged before installing or removing
the bit.
Press in the tool retainer and turn
it
until
the red dots on the tool retainer and the
tool holder are aligned. Release the tool
retainer.
Insert the bit into the tool holder
as
far
as
it will go. Press in the tool retainer and
turn
it a
full 180 degrees. Then release
it
to secure the bit.
1
-
Red dot (Tool holder)
Red
dot
(Tool
retainer)
~
Tool
retainer
II,
To remove the bit, follow the installation procedures in reverse.
Side grip (auxiliary handle)
The side grip swings around to either side,
allowing easy handling of the tool in any
position. Loosen the side grip by turning
it counterclockwise, swing it to the desired
position and then tighten
it
by turning
clockwise.
5