Chapter 9 - Plasma Panel Replacement - KZ-42TS1U
The KZ-32TS1U and the KZ-42TS1U are mechanically different and have separate procedures for the Plasma
Panel removal.
Handling Precautions
•
After removing the plasma panel from the TV, note that there are flex cables located at the bottom and both
sides of the panel that are susceptible to damage. Only rest the plasma panel topside down so the cables
are not damaged. The 32" Plasma panel is shown. The 42" is similar.
Procedure:
In the following pictured steps, you will remove the rear circuit board assembly and the rear shield.
Before you can pull off the plasma panel:
a) Remove the back panel to expose the input circuit board assembly and shield.
Bottom
Flex Cables
Figure 9-1 - Plasma Panel Standing Upside Down
Circuit Board
Assembly
FIGURE 9-2 - BACK WIRES
9. Plasma Panel Replacement - KZ-42TS1U
Panel
Bottom
Top
Shield
23
Flex
Cables