Advertisement
Quick Links
Installation
Instructions
Questions? Call 1-800-561-3344
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
for local inspector's use.
I
MPORTANT –
•
codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
future reference.
Skill level –
•
Installation of this appliance requires
basic mechanical and electrical skills.
Completion time –
•
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
• This kit is for use on models:
JEM25WMC, PEM31BMC, PEM31WMC and
PEM31SMC.
• This kit is cUL listed for installation alone or over
any GE/GE Profile single electric wall oven.
• For easier installation and personal safety, we
recommend that two people install this microwave
oven.
• Unplug the microwave oven before attempting
installation of this kit.
WARNING!
This oven must be plugged into a
properly grounded 3-hole, 120 volt receptacle as required
by the National Electrical Code.
FOR YOUR SAFETY:
WARNING!
Before beginning the installation,
switch power off at service panel and lock the service
disconnecting means to prevent power from being
switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag,
to the service panel.
or Visit our Website at: www.
Save these instructions
Observe all governing
Be sure to leave these
Keep these instructions for
1 to 3 hours
Microwave Oven
Built-In Trim Kits
GEAppliances.ca
PARTS INCLUDED
PARTS
Note: This kit has extra screws to prevent the
technician from spending extra time locating a
replacement in case they lose one during installation.
1
JX827
QUANTITY
1
Base Pan
1
Back Cover
1
Side Bracket
1
Upper Bracket
1
Bottom Bracket
Trim Kit
1
2
Base Support
Brackets
2 required
5 mm x 10 mm
2 extra
Screw A
1 required
4 mm x 10 mm
2 extra
Screw B
4 mm x 12 mm
4 required
Screw C
2 extra
4 mm x 10 mm
10 required
2 extra
Screw D
4 required
4 mm x 16 mm
Screw E
2 extra
Advertisement
Related Manuals for GE JX82
Summary of Contents for GE JX82
-
Page 1: Installation Instructions
JEM25WMC, PEM31BMC, PEM31WMC and PEM31SMC. • This kit is cUL listed for installation alone or over any GE/GE Profile single electric wall oven. • For easier installation and personal safety, we Base Support recommend that two people install this microwave Brackets oven. -
Page 2: Tools You Will Need
Installation Instructions TOOLS YOU WILL NEED LOCATE AND INSTALL THE REAR HOLDDOWN SUPPORTS Set base pan into the front cabinet microwave 2 Phillips Screwdrivers (#1 & #2) oven cutout and center it right and left. Push back until the front flange is against the cabinet front wall. -
Page 3: Install The Microwave Oven
Installation Instructions INSTALL THE BASE PAN INSTALL THE BACK COVER Use the tabs on the bottom of the back cover to place the Disconnect the microwave oven from the receptacle. back cover on the base pan at the bottom of the open Remove everything out of the microwave oven, slot (just below the bottom edge of the oven). - Page 4 Installation Instructions CHECK LEVELING INSTALL THE TRIM KIT FRAME Check the leveling by placing a level at the front and Position the assembled Trim Kit frame around sides of the microwave. It may be necessary to add wood the oven. shims under the bottom duct to level the microwave Open the oven door, and locate the 4 screw front-to-back or side-to-side.