Surveillance Angle Adjustment - HIKVISION DS-2CD2112 Quick Operation Manual

Network Dome Camera· Quick Operation Guide
If required, you can route cables through the side outlet on the
mounting base (as shown in Figure 2-4).
4. Loosen the tilt lock screws, adjust the tilting position in a range
of 65 degrees, and tighten the tilt lock screws.
5. Rotate the black liner to adjust the panning position in a range of
180 degrees until you get the desired surveillance angle.
0°~360°
Figure 2-4
As the lens has already been factory adjusted to the best imaging
effect, you just need to adjust the panning position and tilting
position to get the desired surveillance angle.
6. Reinstall the bubble and tighten the screws.

Surveillance Angle Adjustment

13
Side Outlet
Tilting Adjust
Screw
0°~65°