Hitachi BD-W3300 Instruction Manual page 57

You may set WASH·RINSE·SPIN, or combine them respectively.
(The setting can't be saved.)
In case of water remaining in the drum, set to [SPIN] for [1 min] under [Fuzzy] program before any operation.
The detergent liquid can't be reused.
Otherwise, a lot of foam may be generated, and it causes machine failure.
You can pause the Wash Only setting, however, you cannot add the Rinse or Spin operations and you cannot change things such as the washing time.
If Wash Only is set, the remaining time will be displayed as longer than the spin setting time.
(This is to correct uneven distribution of the washing for the drainage time and spin-drying.)
In order to run the partial operation under the program other than [FUZZY], press the program button put in use to clear all
indications and run the partial operation. (Some program may not be operated.)
Set the HOT
If you will not
perform the HOT
WASH, skip to
Do not set to
HOT WASH for
starched laundry.
Cannot be set
WASH
Press START
button.
Finish the operation
Operate with the set WASH~SPIN mode.
The detergent liquid is drained off. After that, the machine stops.
The machine stops with the rinsing liquid remains inside the tub.
Directly perform washing and spinning without rinsing.
Perform water draining and spinning before rinsing. It stops with the rins-
ing liquid remaining.
Perform water draining and spinning before rinsing.
Perform spinning after draining.
57