Playing The Radio - Honda 2007 Civic Hybrid Owner's Manual

Main Menu Main Menu
To Play the Radio
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob. Adjust the volume
by turning the same knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button (AM or FM button). On the
FM band, ST will be displayed if the
station is broadcasting in stereo.
Stereo reproduction in AM is not
available.
To Select a Station
You can use any of five methods to
find radio stations on the selected
band: TUNE, SEEK, SCAN, the
preset bars, and AUTO SELECT.
Table of Contents
TUNE Use the TUNE knob to
tune the radio to a desired frequency.
Turn the knob right to tune to a
higher frequency, or left to tune to a
lower frequency.
SEEK The seek function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the or
SEEK bar, then release it.
SCAN The scan function samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
The system will scan for a station
with a strong signal. When it finds
one, it will stop and play that station
for about 10 seconds.
If you do nothing, the system will
then scan for the next strong station
and play it for 10 seconds. When it
plays a station you want to listen to,
press the SCAN button again.
PRESET
(1 6) can store one station on AM,
and two stations on FM.
side of the 1. Select the desired band, AM or
FM. FM1 and FM2 let you store
twelve stations.
2. Use the tune, seek, or scan
function to tune the radio to a
desired station.
Pick a preset number (1 6), and
3.
hold it until you hear a beep.
4. Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.

Playing the Radio

Each side of the bars
CONTINUED
109