Table of Contents
Advertisement
2.0 INSTALLING THE DISPLAY
LDP63000 DISPLAY INSTALLATION
The LDP63000 display is intended to be mounted into a panel or enclosure.
The display is provided with a gasket to provide a water-tight seal. The
recommended minimum panel thickness for NEMA 4/IP65 sealing
is 0.060" (1.57 mm).
For panel mounting, prepare the panel cut-out
to the dimensions shown. The supplied
template may be used to mark the cut-out
and hole locations on the panel. After the
panel cut-out has been deburred, slide the
panel gasket over the rear of the display
and onto the mounting studs. Insert the
display into the panel cut-out as
illustrated in Figure 3. Install six #
10-32 keps nuts (supplied) and tighten
evenly for uniform gasket compression.
Do not over-tighten the nuts.
By
using
additional
mounting
accessories, the LDP63000 can be
surface-wall mounted, suspended, or
bottom mounted. Separate installation
instructions are provided with the
mounting accessories.
Environment And Cleaning
The display should be installed in a location that does not exceed the
maximum operating temperature and provides good air circulation. Placing the
system near devices that generate excessive heat should be avoided.
The bezel should be cleaned only with a soft cloth and neutral soap product.
Do NOT use solvents. Continuous exposure to direct sunlight may accelerate
the aging process of the bezel.
3.0 WIRING AND PROGRAMMING THE DISPLAY
Once assembled, the LDP63000 has all the same functions and capabilities of
our DP63x00 Series Intelligent Panel Meters. Therefore, you will find the
appropriate wiring and programming information in a separate manual packed
with your LDP63000 Display. Simply follow the instructions to wire and
program the display for your application.
MOUNTING
PANEL
PANEL
GASKET
FRONT
PANEL
M
/O H
L T
V O
T
E N
R R
C U
M M
C O
N
T IO
IT A
X C
+ E
M M
C O
1
2
3
N /C
D
T E
R A
Y S
C
V A
D )
L A
2 5 0
R E
O A
E L
@
3 A
T IV
S IS
(R E
MOUNTING STUDS AND NUTS
(6 PLACES)
Figure 3, Installing The LDP63000 Into A Panel
6
CONNECT THIS STUD
TO A PROTECTIVE
EARTHING SYSTEM
CASE
VENT
MODULE
HOLES
RETENTION
LATCH (TOP
AND BOTTOM)
MODULE RELEASE
FINGER TAB
(TOP & BOTTOM)
REAR COVER PLATE
Advertisement
Table of Contents
