Toshiba 20HLV86 Service Manual page 35

1-5: DVD DECK (Refer to Fig. 1-5)
1. Short circuit the position shown in Fig. 1-5 using a
soldering iron. If you remove the DVD Deck with no
soldering, the Laser may be damaged.
2. Disconnect the following connectors:
(CP2301, CP2302 and CP2303).
Remove the 4 screws 1.
3.
4. Remove the DVD Deck in the direction of arrow (A).
Remove the 2 screws 2.
5.
6. Remove the Angle Deck-R in the direction of arrow (B).
Remove the 2 screws 3.
7.
8. Remove the Angle Deck-L in the direction of arrow (C).
Pick Up PCB
1
Angle Deck-R
CP2303
NOTE
1. Before your operation, please read "PREPARATION OF
SERVICING".
2. Use the Lead Free solder.
3. Manual soldering conditions
• Soldering temperature: 350 ± 5˚C
• Soldering time: Within 2 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
4. When Soldering/Removing of solder, use the drawing
equipment over the Pick Up Unit to keep the Flux smoke
away from it.
5. When installing the DVD Deck, remove all the soldering on
the short circuit position after the connection of Pick Up
PCB and DVD PCB connector.
DISASSEMBLY INSTRUCTIONS
Short circuit using a
soldering iron.
1
1
3
3
2
(C)
Angle Deck-L
1 2
(B)
DVD Deck
(A)
CP2302
CP2301
1-6: DVD MT PCB (Refer to Fig. 1-6)
1. Disconnect the following connectors:
(CP3808, CP4401 and CP4303).
Remove the 4 screws 1.
2.
3. Remove the Shield FFC, Shield MPEG and DVD MT PCB
in the direction of arrow.
1-7: POWER PCB (Refer to Fig. 1-7)
1. Disconnect the following connectors:
(CP3807, CP3810 and CP3811).
Remove the 4 screws 1.
2.
3. Remove the Power PCB in the direction of arrow.
Fig. 1-5
B1-2
1
1
1
1
Shield MPEG
DVD MT PCB
CP4303
CP3808
CP4401
1
CP3811
1
1
CP3810
1
Power PCB
CP3807
Shield FFC
Fig. 1-6
Fig. 1-7