Uno-Lrc1 Remote Control With Cav6.6 - Russound ST2 Smart Tuner Instruction Manual

UNO-LRC1 Remote Control Operation
Turning the unit on
The tuner is power managed by the CAV6.6 or other
RNET-enabled controller. If the tuner is in standby
mode, any button press of the UNO-LRC1 will bring
the tuner out of standby mode when used with the
UNO keypad.
Selecting the desired tuner
To select a tuner, push
number preassigned to Tuner 1 or Tuner 2, or use the
UNO numeric source inputs at the bottom of the
UNO-LRC1.
Selecting the desired band
Push to toggle between AM/FM reception.
Selecting the desired frequency
Use the Channel and
for manual tuning. To move quickly through the
stations, press and hold the button for more than 1.5
seconds. To directly select a station, enter the three-
or four-digit frequency (1071 for 107.1, etc.).
European regions use five-digit station frequencies.
Frequency Seek
The SEEK function is performed by pressing and
releasing the Select
higher frequency station press
lower frequencies. Tuning begins at the current fre-
quency, seeks upward (or downward) and stops at the
next tuned station. Pushing
tinues the SEEK function. Once the highest frequency

UNO-LRC1 REMOTE CONTROL WITH CAV6.6

and choose the source
or and
or or . To seek
. Press for
or again con-
is reached, the tuner continues SEEK mode at the
lowest frequency.
Frequency Scan
To scan, press and hold then release
tuner scans through tuned stations with a 5-second
preview before moving to the next station. To end
scanning, press again.
Selecting a Bank
To select a bank, press and hold
or for bank down.
Recalling a Memory Preset
Press and
through a loop of all the memory presets for the cur-
rently selected bank. Only configured presets will be
displayed.
Mute
Press the button to mute/unmute the tuner
audio output.
ST2 OPERATION
. The
for bank up
or and to scroll
19