Table of Contents
Advertisement
3.
After using the auxiliary DC jack, be sure
to remove the accessory power plug from
the jack and to close the auxiliary DC jack
cap.
ECS01002
NOTICE
To avoid circuit overload and a possible
G
fuse blowing, do not use accessories re-
quiring more than the maximum rated
capacity for the auxiliary DC jack.
RX10R / RX10LT: Do not connect acces-
sories with a combined requirement of
more than 30 W to the auxiliary DC jack
and helmet shield heater jack.
(See page 74 for the specified fuse am-
perage.)
Do not use an automotive cigarette light-
G
er or other accessory with a plug that
gets hot because the jack can be dam-
aged.
Maximum rated capacity:
DC 12 V, 2.5 A (30 W)
ESU13690
Helmet shield heater jack
(RX10R / RX10LT)
The helmet shield heater jack is located on
the left side of the handlebar.
TIP
The helmet shield heater jack can only be
used if the engine is running.
To use the helmet shield heater jack
1.
Start the engine.
2.
Open the helmet shield heater jack cap,
and then insert the power plug of the hel-
met shield heater into the jack.
Control functions
1. Helmet shield heater jack cap
2. Helmet shield heater jack
3.
After using the helmet shield heater, be
sure to remove its power plug from the
jack and to close the jack cap.
ECS01010
NOTICE
To avoid circuit overload and a possible
fuse blowing, do not use a helmet shield
heater requiring more than the maximum
rated capacity for the helmet shield heater
jack and, when using both the auxiliary DC
jack and helmet shield heater jack, do not
use accessories requiring a combined to-
tal of more than 30 W.
Maximum rated capacity:
DC 12 V, 1.5 A (18 W)
ESU13522
Brake lever
The snowmobile is stopped by braking the en-
tire drive system.
Squeeze the brake lever towards the handle-
bar grip to stop the snowmobile.
1
2
19
Advertisement
Table of Contents
