Makita BPT350 Instruction Manual page 8

Place pin nails against the magazine and insert into the
slit all the way. (Be careful to place pin nails in the right
direction.)
Keeping pin nails in this position, insert these nails all the
way into the driver guide.
Return the magazine to the original position and lock it
with the locking lever.
CAUTION:
Do not use deformed connected pin nails. Use pin
•
nails specified in this manual. Using pin nails other
than those specified may cause pin nail jamming
and breakage of the pin nailer.
Unloading pin nailer
CAUTION:
When removing pin nails, make sure that your
•
fingers are not placed on the trigger or the lever and
the battery cartridge is removed from the pin nailer.
Misfiring may cause personal injuries and property
damage.
Remove the battery cartridge.
Press the locking lever and slide the magazine.
Take out pin nails from the magazine slit.
Nose adapter
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger or the lever and the battery cartridge
is removed before installing the nose adapter.
2
3
4
007736
When firing pin nails on the material to be fastened with
easily-marred surfaces, use the nose adapter. To install
the nose adapter, place it over the driver guide cover so
that the protrusion inside the nose adapter fits to the slit
in the driver guide cover.
When not in use, store the nose adapter in the holder at
the back end of the magazine to keep it from being lost.
1
1. Driver guide
cover
2. Protrusion
3. Nose adapter
4. Holder
Hook
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger or the lever and the battery cartridge
is removed before using the hook.
007737
CAUTION:
Do not hang the hook from the waist belt. Dropping
•
the pin nailer, which is caused by the hook
accidentally coming out of place, may cause
misfiring and personal injuries.
011940
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw. To
remove, loosen the screw and then take it out.
Hex wrench storage
011941
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
8
1. Groove
1
2. Hook
3. Screw
2
3
1. Hex wrench
1