Pioneer PDA-5003 Operating Instructions Manual page 66

Installation and Connections
Connection of composite SYNC analog RGB
source
Make composite SYNC connections for a component
with output that has the vertical synchronization signal
layered on top of the horizontal synchronization signal.
When connecting to ANALOG RGB IN (INPUT1)
INPUT1
ANALOG RGB OUT ANALOG RGB IN
(D-Sub) (D-Sub)
On-screen setup is necessary after connection.
Please see pages 18 to 21.
When connecting to ANALOG RGB (INPUT5)
[Connections for PDA-5003]
ANALOG RGB
G(ON SYNC) B R VD
HD (H/V SYNC)
When using INPUT5, set the impedance selector switch
to match the output impedance of the connected
component's synchronization signal.
When the output impedance of the sync signal is below
75 Ω remove the video card and set the impedance
selector switch to 75 Ω (page 6).
On-screen setup is necessary after connection.
Please see pages 18 to 21.
Note
When making composite SYNC connections, do not connect
anything to the VD jack. If connected to, the picture may not be
displayed properly.
10
En
INPUT5
Connection to a personal
computer
Connection method differs depending on the computer
type. When connecting, please thoroughly read the
computer's operating instructions.
Before making connections, be sure to make sure that
the personal computer's power and display's main power
is off.
For the PC input signals and screen sizes that the display
is compatible with, please refer to the Plasma Display's
Operating Instructions.
Connection of separate SYNC analog RGB
source
Make separate SYNC connections for a personal
computer that has RGB output separated into 5 output
signals: green, blue, red, horizontal synchronization signal,
and vertical synchronization signal.
When connecting to ANALOG RGB (INPUT5)
[Connections for PDA-5003]
ANALOG RGB
G(ON SYNC) B R HD (H/V SYNC) VD
When using INPUT5, set the impedance selector switch
to match the output impedance of the connected
computer's synchronization signal.
When the output impedance of the sync signal is below
75 Ω remove the video card and set the impedance
selector switch to 75 Ω (page 6).
On-screen setup is necessary after connection.
Please see pages 18 to 21.
INPUT5