Playing Back A Tape With Added Sound - Canon ZR500 Instruction Manual

58
Playing Back a Tape with Added
Sound
You can select to play back Stereo 1 (original sound), Stereo 2 (added sound), or adjust
the balance of both sounds.
~~~)
I
r~ I~~I
AUDIO SETUP
1~112bit
AUDIO STERE01
1. Open the FUNC. menu, select
(~T)
the
TI3
icon and press (@).
2. Select
(~T)
the [AUDIO SETUP] menu and press (®). Then, select
(~T)
the [12bit AUDIO] option and press (@).
3. Select
a
setting option and press
(w )
to save the changes.
• STERE01: Plays back the original sound.
• STERE02: Plays back the added sound.
• MIX/FIXED: Plays back Stereo 1 and Stereo 2 in the same level.
• MIX/VAR.: Plays back Stereo 1 and Stereo 2. The mix balance can be adjusted.
• If you select an audio setting other than [MIX/VAR.], close the menu.
To adjust the mix level when you select [MIXNAR.]:
4. From the [AUDIO SETUP] menu select
(~T)
the [MIX BALANCE]
option and press (@).
5. Adjust ( .....
~)
the mix level between ST-1 and ST-2 and press (@) to
save the changes, then close the menu.
o
The camcorder resets to [STERE01] when you turn the camcorder off.
However, the mix balance is memorized by the camcorder.
o
Audio dubbing cannot be performed with your camcorder.