Samsung SPE-101 User Manual page 22

network connection and setup
3. In the <Address> pane, provide the
necessary information.
 MAC (Ethernet) Address : The MAC
(Ethernet) address assigned to
the network device will be set and
displayed automatically so you don't
need to assign it manually.

M
You can configure the static IP settings
only if the DHCP checkbox is unchecked.
If using a broadband router
 IP Address : Enter an address falling in
the IP range provided by the Broadband
router.
ex) 192.168.1.2~254, 192.168.0.2~254,
192.168.XXX.2~254
 Subnet Mask : The <Subnet Mask>
of the Broadband router will be the
<Subnet Mask> of the network video
encoder.
 Gateway : The <Local IP Address>
of the Broadband router will be the
<Gateway> of the network video encoder.

M The settings may differ depending on the connected Broadband router model.
For more information, refer to the user manual of the applicable router.

Refer to the "Port Range Forward (Port Mapping) Setup" section of the Broadband router's
documentation. (Page 25)
If not using a broadband router
For setting <IP Address>, <Subnet Mask>, and <Gateway>, contact your network administrator.
4. In the <Port> pane, provide necessary
information.
 HTTP Port : Used to access the
network device using the Internet
browser, defaulted to 80.
Use the spin button to change the
HTTP Port value.
 VNP Port : Used to control the video
signal transfer, defaulted to 4520.
5. Enter the password.
This is the login password for the "admin" user who accesses the network device.
The default password is "4321".
22_ network connection and setup