If the parameter is not yet set or is not settable, the default value placed in the
parameter field shall be 6 ASCII blank characters(20
checked for validity by this controller.
The Specified cycle count over device lifetime (parameter code 0003
parameter provided by this controller. The specified cycle count over device
lifetime parameter shall not be savable by initiator via the LOG SELECT
command. The parameter value is a 4 byte binary number.
The value indicates how many stop-start cycle may typically be executed over the
lifetime of the device without degrading the device's operation or reliability
outside the limits specified by the manufacture of the device.
The accumulated start-stop cycles (parameter code 0004h) is a parameter provided
by this controller. The accumulated start-stop cycles parameter shall not be
savable by initiator via the LOG SELECT command. The parameter value is a 4-
byte binary number. The value indicates how many start-stop cycles the device has
detected since its date of manufacture.
Application Client Page (Page Code = 0F
The application client page (see Table 5.31) provides a place for application clients
to store system information. The page code for the application client page is 0Fh.
Bit
Byte
0
1
2
(MSB)
3
5 COMMAND DESCRIPTIONS
Table 5.31 Application Client Page(Page Code = 0F
7
6
5
Reserved
0
0
0
0
0
0
)
H
4
3
Page Code
0
1
Reserved
0
0
Page Length (4000
H
OEM MANUAL:K6602924
). The field shall not be
H
) is a
H
)
H
2
1
1
1
0
0
)
(LSB)
Revision: 1 / Date: 2003.03.06
Page: 107 / 273
0
1
0
(cont'd)