What To Do If - Zanussi ZWH 7120 P User Manual

What to do if...

The appliance does not start or stops during
operation. Certain problems are due to lack of
simple maintenance or oversights, which can
be solved with the help of the indications de-
scribed in the charts, without calling out an en-
gineer.
During appliance operation it is possible that
the red pilot light of the button 9 flashes, the
Fault code and malfunc-
tion
Problem with the water
supply
Problem with the water
drainage
26
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose or the inlet valve filter are blocked.
• Clean the water inlet filters (read "Cleaning the water inlet filters" for more
details).
The drain hose is squashed or kinked.
• Check the drain hose connection.
The drain filter is clogged.
If the appliance stops working without discharging the water , first carry out an
emergency drain:
• turn the programme selector dial to
• unplug the appliance;
• close the water tap;
• if necessary, wait until the water has cooled down;
• unscrew the drain hose from the rear support (see "Frost precaution") and
unhook it from the sink or spigot;
• let it run along the floor;
• place a bowl on the floor and place the end of the draining hose into the
bowl. The water should drain by gravity into the bowl. When the bowl is full,
empty it. Repeat the procedure until water stops flowing out ;
• screw the draining hose to the rear support and reposition it;
• open the door and remove the laundry;
• carry out the drain filter cleaning as described in "Cleaning the drain filter";
• at the end of cleaning action, close the door and insert the mains plug
again;
• run a drain programme to check if the appliance works now.
display shows a fault code and the buzzer
sounds to indicate that the appliance is not
working.
Before contacting your local Service Centre,
please carry out the checks listed below.
Possible cause / Solution
;
www.zanussi.com