Assembly; Unpack Pressure Washer; Attach Accessory Holders - Husqvarna Pressure Washer Operator's Manual

Assembly

Read entire operator's manual before you attempt
to assemble or operate your new pressure washer.
Your pressure washer requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your pressure
washer, please call the pressure washer helpline at
(877) 224-0458. If calling for assistance, please have the
model, revision, and serial number from the identification
label available.

Unpack Pressure Washer

1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner from
top to bottom.
3. Ensure you have all included items prior to assembly.
Items in the carton include:
• Main Unit
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Hose Wrap
• Wheels (2)
• Caster Wheels (2)
• Oil Bottle
• Oil Funnel
• Spray Gun Holder Wireform
• Battery Float Charger
• Operator's Manual
• Owner's Registration Card
• Multi–Colored Spray Tips (5)
• Handle Pin
• Axle Studs (2)
• Retaining Pins (2)
• Washers (4)
• Keys (2)
• Metal Spring Clips (2)
• Plastic Knobs (1)
• Screws (5)
• Hex Key Wrench
To prepare your pressure washer for operation, you will
need to perform these tasks:
1. Fill out and send in registration card.
2. Attach hose wrap, metal spring clips, spray gun holder
wireform and handle pin to main unit.
3. Install wheel kit on main unit.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect spray tip to nozzle
extension.

Attach Accessory Holders

All assembly instructions in this section will be viewing from
engine end of unit.
1. Place hose wrap (A) over holes (B) on end of main unit.
Using provided hex key wrench, attach hose wrap with
three screws (C). Tighten by hand.
A
C
2. Insert spray gun holder wireform (D) through holes on
right side of unit frame. Hold wireform in place and
attach a plastic knob (E) from inside of unit. Tighten by
hand.
E
3. Using provided hex key wrench, attach metal spring
clips (F) to left side frame of unit with screws (G).
Tighten by hand.
G
B
D
F
7