Installing The Rechargeable Battery - Cisco TelePresence VX Clinical Assistant Installation And User Manual

Installing the Rechargeable Battery

The system's rechargeable battery is disconnected for
shipping and must be connected for proper operation.
NOTE: Ensure AC Power is not connected to the cart
when installing the battery.
1. Remove the ACCESS PANEL on the lower column
by unscrewing the THUMBSCREW (1) near the top
of the plate.
2. Remove the WING NUT (1) holding the BASE PLATE
in place.
3. Remove the BASE PLATE by gently pulling the plate
forward and then up.
4. Locate the YELLOW BATTERY CONNECTOR that
extends from the battery and plug into the POWER
SUPPLY UNIT.
5. Replace the BASE PLATE and the ACCESS PANEL.
If the BATTERY has enough charge, then the VX Clinical
Assistant is ready to be configured and begin making
calls.
If the BATTERY does not have enough charge, provide
power by plugging the system into an appropriate
outlet (120V or 240V) -- this charges the BATTERY
while powering the system with AC power.
It is recommended that the unit is initially charged 4-6
hours or until the batter meter indicates a full charge.
Make sure the display is ON if it has not turned on
automatically.
141299.21 Cisco TelePresence VX Clinical Assistant
ACCESS PANEL
NOTE: Providing power to the system via the AC
power cord will automatically switch the system from
battery power to AC power; the battery power will
shut off and will begin to charge from the AC power.
Ensure the POWER SWITCH is in the OFF position
when connecting to AC power, and then switch to the
ON position to use AC power and charge the battery.
TM CTS-CA2-K9/CTS-CA2-P240V-K9 v1.2 | 2013 JAN | © 2012-2013 Cisco Systems, Inc. All rights reserved.
BATTERY CONNECTOR
BASE PLATE
50A FUSE
(Field Replaceable -- see
Troubleshooting Section)
BATTERY MAINTENANCE: To insure maximum longevity
of the battery, the VX Clinical Assistant should periodi-
cally be operated on battery power until the "Low Bat-
tery " warning comes on. Once the warning sounds the
system should be reconnected to an AC power source
until the battery is fully charged.
11