Upper Control Panel; Power Switch; Eject Button; Remote Buttons - Sony SRW-5800 Operation Manual

2-1-1 Upper Control Panel

1 POWER switch

9 PHONES jack
a POWER switch
Pressing on the '(' side of this switch powers the unit and
lights up the information display (see page 20) and color
display (see page 17). To turn the unit off, press on the 'a'
side of the switch.
b WARNING indicator
This lights when there is a fault in the unit. You can check
the details on the lower control panel.
For details, see "Error Messages/Warning Messages/
Condition Messages" on page 149.
c ERROR indicator
This lights when a serious problem occurs, such as an
operational malfunction or system internal error.
You can check the details on the lower control panel.
For details, see "Error Messages/Warning Messages/
Condition Messages" on page 149.
d CHANNEL CONDITION indicators
These show the status of the playback signal.
Blue: The playback signal status is satisfactory.
Yellow: The playback signal is somewhat degraded, but
playback is possible.
However, if this indicator remains lit continuously,
head cleaning is required.
Red: The playback signal has deteriorated.
If this indicator remains lit continuously, head
cleaning or internal inspection is required.
16
2-1 Control Panel
2 WARNING indicator

3 ERROR indicator

4 CHANNEL CONDITION indicators

5 EJECT button

6 Format indicators

7 REMOTE buttons

8 PHONES level control
Cassette compartment
e EJECT button
Pressing this button automatically ejects the cassette after
several seconds.
f Format indicators (Digital BETACAM/HDCAM/
HDCAM SR)
These show the format of the cassette loaded into the unit.
g REMOTE buttons
Press one of the following buttons, to select how the VTR
is controlled.
NETWORK 1: This button lights when pressed, enabling
access from the network connected to the
NETWORK 1 connector on this unit.
NETWORK 2: This button lights up when pressed,
enabling file transfers between the VTR and the
shared file server, and control of the VTR from the
web client.
Note
This button operates only when the optional HKSR-
5804 Network Interface Board is installed.
1(9P): This button lights when pressed, enabling this unit
to be controlled from a device connected to the
REMOTE 1-IN(9P) connector or REMOTE 1-I/
O(9P) connector.
2(50P): This button lights when pressed, enabling this unit
to be controlled from a device connected to the
REMOTE 2 PARALLEL I/O(50P) connector.