Contents 1 Important Safety Notice 2 Your Wireless Microphone and Bluetooth Speaker ® Introduction What's in the box Overview of the unit 3 Get started Connect power Switch on the Bluetooth speaker ® Install/replace microphone batteries 4 Play Sing along through the wireless microphone Play from a Bluetooth enabled device...
1 Important h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. i Do not defeat the safety purpose of the polarized or grounding-type plug. Safety A polarized plug has two blades with one wider than the other.
n Refer all servicing to qualified service Information about the use of batteries: personnel. Servicing is required when the apparatus has been damaged in any Caution way, such as power-supply cord or plug • is damaged, liquid has been spilled or Risk of leakage: Only use the specified type of batteries.
Page 6
However, there is no negative consequences on the environment and guarantee that interference will not occur in a human health. particular installation. Please visit www.recycle.philips.com for If this equipment does cause harmful additional information on a recycling center in interference to radio or television reception, your area.
Page 7
U.S. and other countries. The Bluetooth word mark and logos are ® registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Philips is under license. Note • The type plate is located on the back of the unit.
Philips offers, register your product at www.philips.com/welcome. Overview of the unit If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the Wireless microphone back of the apparatus.
Page 9
Bluetooth speaker ® d ef a Power indicator • Indicate the power status. • Turn the unit on/off. c Bluetooth indicator ® • Indicate the Bluetooth status. ® d -/+ • Adjust volume. • (Press) pair with a Bluetooth enabled ®...
3 Get started • To switch the unit to standby mode, press on the top panel. • To switch the unit on from standby mode, press again. Always follow the instructions in this chapter in sequence. • If the speaker stays idle for more than 15 minutes, it Connect power switches to standby mode automatically.
Page 11
Push back the battery cartridge, then close the battery compartment. Note • If you are not going to use the microphone for a long time, remove the batteries. • New batteries installed in the microphone support up to 25 hours of continuous use. •...
Settings -> General -> the Bluetooth indicator turns solid ® About -> AEA7000 -> Find App for blue. Accessory to install the app. Find and download a tutorial from The Voice: On Stage, then tap SING for...
Play from a Bluetooth ® enabled device Note • The effective operation range between the Bluetooth ® speaker and your Bluetooth enabled device is ® approximately 10 meters (30 feet). • To pair with a Bluetooth enabled mobile device, make ®...
Select 'PHILIPS_AEA7000' on your Play and charge your iPad Bluetooth enabled device and if necessary ® through the dock connector input '0000' as the paring password. directly » After successful pairing and connection, the Bluetooth indicator on the ® speaker turns solid blue and the Compatible iPad speaker beeps twice.
Charge the iPad The docked iPad begins to charge as soon as the unit is connected to AC power. Play from an external device You can also listen to an external audio player through the Bluetooth speaker. ® AUDIO-IN Connect a 3.5mm audio cable (not supplied) to: • the AUDIO-IN socket on the back of the Bluetooth...
5 Product Dimensions (W x H x D) information 300 x 124 x 156mm • Speaker 162 x 317 x 162mm • Microphone Weight Note 1.3 kg • Speaker 0.3kg • Microphone • Product information is subject to change without prior notice.
Bluetooth speaker for more than 10 requesting service. If the problem remains ® unsolved, go to the Philips Web page (www. seconds to set up wireless connection philips.com/support). When you contact Philips, manually. make sure that the device is nearby and the Howling or echo from the wireless model number and serial number are available.