Correct Usage - Toshiba MCY-MAP0401HT Owner's Manual

12
2
5
3
11
UNIT LOUVER
button (Unit / Louver select button)
Selects a unit number (left) and louver number
(right).
UNIT button:
If two or more indoor units are controlled by one
remote controller, use this button to select a unit to
adjust its air blow direction.
LOUVER button: (4-way cassette type only)
Selects a louver to control when adjusting the
louver lock setting or wind direction setting
separately for each louver.
12
button
Adjusts the set temperature.
Select the desired set point by pushing
or TEMP.
OPTION:
Remote controller sensor
Normally the temperature sensor of the indoor unit
senses the temperature. The temperature around the
remote controller can also be sensed. For details,
contact your dealer.
* Do not use the function when the air conditioner is
controlled in a group.
15-EN
1 8
9
10
4
11
7 6
TEMP.
4

Correct usage

• When you use the air conditioner for the first time or change the settings, follow the procedures below.
From next time, pushing the button starts running of the air conditioner with the chosen settings.
Preparation
Turn on the power switch
• When turned on, the separation line appears and
* The remote controller will not work for about 1 minute after turning on the power. This is not a
malfunction.
REQUIREMENT
• Keep the power switch turned on during use.
• When you resume using the air conditioner after a long period of disuse, turn on the power switch at least 12
hours before starting running.
Operations
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
1
Push the button.
The operation lamp lights up.
2
Push the "MODE " button to select a
operation mode.
Each time you push the button, the operation
mode and its icon change in the following order:
Heat Dry Cool
Fan
(Dehumidify)
" Dry" is not available for the concealed duct
high static type.
3
Push the button to stop running.
The operation lamp turns off.
– 8 –
blinks on the remote controller display.
Changing the fan speed
1
Push the "FAN " button to select a fan
speed.
• Each time you push the button, fan speed and
its indication change in the following order:
(" Auto" cannot be selected in the FAN
1
mode.)
2
Auto High Medium
• When heating, if the room does not heat up
using " Low", select " High" or
" Medium".
• The temperature sensor detects the return air
temperature at the indoor unit, which may
slightly differ from the actual room temperature
depending on installation condition. Set
temperature is a target of room temperature.
• The fan speed selection function is not available
for the concealed duct high static type. Fan
speed is fixed and the indicator is fixed to
" High".
Low
EN
16-EN