Operating Instructions; Starting And Operation; Controls - Husqvarna 968999189 / ZTH6123KOLA Operator's Manual

OPERATING INSTRUCTIONS

Run engine full throttle to make sure wheels do
not rotate. Readjust if any rotation occurs.
Repeat the whole process for the opposite side
and tighten the nuts against the ball joints.
Turn machine off.
Reinstall the seat rod and check the wiring
harness to the seat safety switch for a good
connection and return the seat to the normal
position.
Operating instructions

Starting and operation

Operator must be sitting in the seat. Engage
the park brake, blades disengaged and the
motion control levers in the neutral slots.
Set choke (if needed) turn key and release as
soon as engine starts. Adjust throttle to half
and shut choke off.
Release parking brake.
Close motion control levers.
Engage blades and set RPM to maximum.
CAUTION: Be sure all persons are clear of the
area before engaging blades.

Controls

Be familiar with all controls their function and
how to operate them before starting the ma-
chine.
Motion control levers on each side of the
console control the direction of movement. See
page 7. The left lever controls the flow of oil
from the left hydro pump to the left wheel
motor. The right lever controls the flow of oil
from the right hydro pump to the right wheel
motor.
NOTE: To begin motion the operator must be in
Motion Control Lever Pattern
the seat and the parking brake disengaged
(Right Side)
before the motion control levers can be moved
from the neutral slots or the engine will kill. FIG
FIG - 10
- 10
17