Setting/Changing The Disc Name; Setting/Changing An Id Number - Sony DKR-700 Instructions For Use Manual

Setting/Changing the Disc Name

1
1) Connect a video monitor to the appropriate
connector(s) on the rear panel of the DKR-700/
700P (see page 16(E)).
2) Insert the disc whose name is to be added or
modified into the DKR-700/700P, after making
sure that it is not write-protected (see page
18(E)).
2
Press the DISC/NAME key while holding down
the SHIFT key.
The disc name input display appears.
Disc Name:
[ ] Select [EXE] End
µ
3
Press the or key to display the cursor and
¿ ÷
move it to the position where characters are to be
entered or changed.
Disc Name:
[ ] Select [EXEC] End Mm
4
Enter the desired character (up to 15 characters).
Disc Name:Photo
[ ] Select [EXEC] End Mm
5
Setting an ID number
1
2
Cursor
3
The entered character is displayed, the cursor
moves one position to the right.
Check the entered name, and press the EXE key if
it is correct.
Note
Once a disc name is set, it can not be erased.

Setting/Changing an ID Number

Press the ID NO key.
The ID number input display appears.
ID No:
Mode:Off
[ ] Select [ ] Set µ Mm
Using the or key, move the cursor (") to the
≥
˘
"ID No" line.
Press the or key to display the cursor (_).
÷
¿
ID No:
Mode:Off
[ ] Select [ ] Set µ Mm
Cursor
(continued)
33(E)