Table of Contents
Advertisement
9.
With the hood open, secure the (3) bags in
place. The back of the bags will hook over
the mounting tabs on the hitch assembly.
Figure 5.
10.
Close the hood, and latch the draw latch over
the draw latch keeper on the hitch assembly.
Figure 5.
11.
Install the (2) linkage assemblies to the (2)
support brackets on hitch assembly and the
(2) support brackets on the frame. The
shorter linkage connects to the support
bracket on the hitch assembly. Figure 6.
NOTE: The linkage assemblies may need to be
adjusted. Using (2) 3/4" wrenches, loosen the 1/2"
jam nut on the longer linkage. Turn the turnbuckle
in the appropriate direction to shorten the linkage
assembly. Turn until the slop is taken out of the
linkages. Tighten the jam nut against the
turnbuckle.
12.
Secure the front of the linkage assemblies
using the hairpin secured by the lanyard.
Secure the rear of the linkages using the (2)
990654, cotter pins provided. Figure 6.
13.
Place the hose on the inlet and secure with
the hose clamp.
ASSEMBLY
HOOD ASSEMBLY
DRAW
LATCH
MOUNT
TABS
DRAW LATCH
KEEPER
10
FIGURE 5
SUPPORT BRACKET
TURNBUCKLE
LINKAGE ASSEMBLY
LANYARD
SUPPORT BRACKET
FIGURE 6
BAG
Advertisement
Table of Contents
