Telnet & Ssh Commands - D-Link DWL-2100AP Command Line Interface Reference Manual

TFTP Commands:
Command:
tftp get Get a file from TFTP Server.
tftp uploadtxt Upload the configuration of the device to TFTP Server.
tftp srvip Setup the TFTP Server IP address.
tftp update Update the file to the device.
tftp info Information about the TFTPC setting.
get telnet Display Telnet Status of current login, number of login attempts, etc.
get timeout Display Telnet Timeout in seconds
set telnet Set Telnet Access/SSL Mode to enabled or disabled
Set Telnet Timeout in seconds, 0 is never and 900 seconds is the
set timeout
maximum <0-900>
SSH Commands
Command:
ssh showuser Show SSH User
ssh setrekey Set SSH Rekey
ssh loaddefault Load SSH Default Setting
ssh showalgorithm Show SSH Algorithm
802.11 b/g Access Point Command Line Interface Manual
Function
Function
22
12
T & SSH C
ELNET
Syntax
tftp get Filename<string>
tftp uploadtxt Filename<string>
tftp srvip <xxx.xxx.xxx.xxx>
tftp update
tftp info
get telnet
get timeout
set telnet <0:1:2>
Explanation:
0=disable telnet and enable SSL
1=enable telnet and disable SSL
2=disable both telnet and SSL
set timeout <0-900>
Syntax
ssh showuser
ssh setrekey [0-3]
Explanation:
0:10Min
1:30Min
2:60Min
3:Never
ssh loaddefault
ssh showalgorithm
OMMANDS