D-Link DES-1228/ME User Manual page 145

Destination IP
DSCP (0-63)
Protocol
Port Number
To view the settings of a previously correctly configured rule, click
To configure the Access Rule for Ethernet, open the Access Profile Table and click Modify for an Ethernet entry. If no entry
exists only the Add button will be displayed however when an entry already exists a corresponding Modify button will also be
displayed. This will open the following window:
The user may display a particular Access ID entry by clicking the corresponding View button.
To remove a previously created rule, select it and click the
DES-1228/ME Layer 2 Fast Ethernet Managed Switch
Enter an IP Address mask for the destination IP address.
This field allows the user to enter a DSCP value in the space provided, which will instruct the
Switch to examine the DiffServ Code part of each packet header and use this as the, or part
of the criterion for forwarding. The user may choose a value between 0 and 63.
This field allows the user to modify the protocol used to configure the Access Rule Table;
depending on which protocol the user has chosen, or configured in the Access Profile Table.
Enter the switch port number(s) to which you wish this rule to apply.
Figure 9- 6. Access Rule Display window (IP)
Figure 9- 7. Access Rule Table window (Ethernet)
in the Access Rule Table to view the following window:
button. To add a new Access Rule, click the Add button:
132