Using The Polling Function - Sharp LASER PRINTER Operation Manual

TRANSMISSION AND RECEPTION USING THE POLLING FUNCTION

USING THE POLLING FUNCTION

A document should not be loaded in the machine when the following operation is performed. When used in conjunction
with the timer transmission function, only one polling job can be stored.
NOTE
If the other machine has a polling security function (refer to page 3-8), use the key operator program to program your own fax number
(refer to page 8-4), and ask the operator of the other machine to appropriately program your fax number in that machine.
1
Touch the SPECIAL MODES key in fax mode,
and then touch the POLLING key.
SPECIAL MODES
STANDARD
POLLING
RESOLUTION
DUAL PAGE
EXPOSURE
SCAN
2
Touch the OK key.
AKER REDIAL
OK
NOTE
• To cancel the operation
Press the JOB STATUS key and then cancel the operation as explained on page 2-6.
Manual polling
A document should not be loaded in the machine when the following operation is performed. Manual polling is
begun on the signal of the other party.
1
Touch the SPEAKER key in fax mode, and dial
the number of the other machine.
SPEAKER
AX MEMORY:100%
ADDR
AUTO RECEPTION
DIRE
SUB
2
Touch the SPECIAL MODES key.
SPECIAL MODES
STANDARD
RESOLUTION
3-6
The POLLING key is
highlighted and the polling
icon appears.
To cancel polling, touch the
POLLING key once again to
cancel the selection.
You will return to the initial
screen.
A one-touch key or the
RE
REDIAL key can also be
used.
If you have connected an
extension phone to the
machine, you can lift the
extension phone and then dial.
3
Dial the number of the other fax machine or
touch an auto-dial key (one-touch or group key)
(refer to page 2-5).
SPE
CORPO.TPS
SHARP GROUP
NOTE
When performing serial polling, an auto-dial key that includes
a sub-address or passcode (page 4-2) cannot be selected.
4
When you have finished entering the
destination(s), press the START key.
3
When you hear the fax tone from the other
machine, press the POLLING key.
ER POLLING
L PAGE
EXPOSURE
SCAN
4
Polling reception begins.
If you lifted an extension phone to dial, replace the
extension phone. Your machine prints the document after
receiving it from the sending machine.
NOTE
Serial polling cannot be performed manually. When polling
reception ends, repeat steps 1 through 4.
If you are performing serial
polling, touch the NEXT
ADDRESS key and repeat
this step. (Page 3-3)
JOB STORED appears in
the screen.
Your machine prints the
document after receiving it
from the sending machine.
POLLING appears in the
display.