Getting Started; Setup And Connection; Channel Marker - GE TV User Manual

Getting Started

Setup and Connection

Step 1:
Unpack the TV and remote control.
Step 2:
Connect your TV. Connect the cable from your cable system or off-air
antenna to the cable in-jack on the back of the TV, as shown.
Step 3:
Plug in the TV. Plug the end of the power cord into the wall outlet,
matching the wide blade of the plug with the wide slot in the outlet. Be
sure to insert the plug completely.
Step 4:
Put batteries in the remote.
1. Remove the battery compartment cover from the back of the remote.
2. Insert batteries as shown, matching the + and – ends of each battery in
the compartment.
3. Replace the cover.
Step 5:
Turn on the TV.
• Press the POWER button on the remote or front panel.
Read the next section, Using the Menu System , which is a brief overview
of the basic rules for getting around in the menus using the remote or TV's
front control panel.
Step 6:
Auto Channel Search.
Perform an Auto Channel Search (described in the Channel menu section).

Channel Marker

The Channel Marker comes up when you first turn on the TV, change
channels, or press the DISPLAY button.
08:59 Displays the current time.
WRTV Displays the label assigned to the current channel.
06 Displays the current channel.
Sleep Displayed when the Sleep Timer has been set.
Stereo Displayed when the current channel is in Stereo.
CC Displayed when Closed Captioning is available.
Mute Displayed when you mute the audio.
Unlocked Display whether the V-Chip system is locked, unlocked, or
disabled.
1:30 Displayed to count down time left on the commercial skip timer.
2
Caution: If you choose to use a stand
with your TV, take precautions that the
stand or other furniture the TV is placed
on is properly located and of adequate
size and strength to prevent the TV from
accidentally being pushed off, pulled off,
or tipped over. This could cause damage
to the TV and/or personal injury.
ANTENNA, CABLE, CABLE BOX OR VCR
TV
08:59 WRTV
Sleep Stereo
Mute Unlocked
The Channel Marker shown is just an
example of what your screen may look like.
You can press MENU or CLEAR to make the
Channel Marker disappear; it will disappear
automatically after a short time.
CABLE/
ANTENNA
06
CC
1:30