Anti-Tip Bracket Installation - GE 36" Owner's Manual

Anti-tip
• The kit supplied with the unit contains 2 lag
bracket
installation
• Measure the opening where the unit is to be
• Measure up 81 1/2" from the floor. Mark this
• Using a level, draw a horizontal line on the wall
• Locate at least 2 studs on the back wall.
• Place the bottom of the wall bracket with tabs
• The anti-tip wall bracket has a series of holes.
• Mark an additional hole at each end
• Drill 1/2" holes into the wall board
• Drill 3/16" holes into wooden studs where
16
bolts and 4 toggles with bolts. The wall bracket
will be attached to the wall in 4 places.
installed. Mark the center with a vertical line.
point on the wall.
at this height.
Mark these points on the horizontal line.
on the horizontal line. Align the center notch
on the bracket with the center line on the wall.
Select 2 holes that match with the located
studs. Make sure the holes selected are
on the center of the studs. Mark the wall
at these points.
of the bracket. If one of the studs is closer
to the end of the bracket, mark an additional
hole towards the center of the bracket.
at the locations marked for the toggles
to be mounted (not the stud markings).
marked. If steel stud construction, drill 1/2"
holes into the studs where marked. You will
use 2 toggles with the metal studs.

Anti-Tip Bracket Installation

36" All-Refrigerator and All-Freezer Units
Center
Two Additional
Hole Locations at
Ends of Brackets
Wall Studs
Line on Wall
Center
Wall Bracket
Line On Wall