Faqs - Hitachi LE32ECD05AU User Manual

FAQs

Problem Possible cause
No picture and The power cord is not
sound. plugged in.
The wrong input source is
selected.
The input source has failed
to connect with the TV.
No sound. The volume control is set to
minimum.
The mute
remote control is pressed.
An incorrect sound system
mode is set.
No picture, or The colour system setting does
monochrome not match the programme.
picture only. The sound system setting does
not match the programme.
Sound or Some equipment that causes
picture interference is close to the
interference. TV.
More than one device is
plugged into the same
power outlet.
An incorrect sound system
mode is set.
PVR recording You may not have removed
failed, or "DISK your USB device after the last
NOT READY" is recording, which is necessary
displayed. to protect the device from
damage.
NOTE: A few bright or dark dots occasionally appearing on the TV screen is normal.
If you cannot solve the problem, contact the after sales support line on the number
listed below.
Possible solution
Plug the power cord into a
suitable outlet.
Select the correct input source.
Make sure the input source is
correctly connected.
Press the
increase the volume.
button on the Press
to restore/increase the volume.
Set a correct sound system
mode from the main menu to
match your TV.
Select the appropriate colour
system setting.
Select the appropriate sound
system setting.
Keep interference-causing
equipment away from the TV.
Plug the power cord into
another, separate power outlet.
Set a correct sound system
mode from the main menu to
match your TV.
Remove the USB device
after each recording if you
experience recording problems.
If "DISK NOT READY" is
displayed, remove the device,
reconnect and then proceed
with your recording.
button to
or the (or ) button
45