Table of Contents
Advertisement
PWR LED
SIGNAL LED
2.3a LED DESCRIPTION (VEGA WIRELESS CAMERA WLAN)
Three LED options indicate a different camera status, as follows:
• PWR: Vega Wireless Camera's power
• SIGNAL: information on WLAN connection
• STATUS: information on remote connection
The LEDs can act as follows:
PWR
OFF
Camera is OFF
Blinking
ON
Camera is ON
When the Vega Wireless Camera WLAN is powered, the device goes through the following stages:
1. Vega Wireless Camera's power: PWR LED is ON;
2. Start of the Operating System: LED is steady ON for about 30 seconds;
3. Status LED steady ON for about 10 seconds;
4. WLAN unit identification: Status LED turns OFF and SIGNAL LED turns ON in the rear panel. In case of
problems with the WLAN unit, the Status LED will blink for about 10 seconds and the Vega Wireless Camera
can be used only through the LAN port.
5. Start of the image capture after about 2 minutes: Status LED is ON.
2.3b LED DESCRIPTION (VEGA WIRELESS CAMERA GPRS)
Three LED options indicate a different camera status, as follows:
• PWR: Vega Wireless Camera's power
• SIGNAL: information on GSM network
• STATUS: information on remote connection
16
LAN port
RESET button
PWR connector
OFF
-
Blinking
ON
Antenna connector
SIGNAL
WLAN unit is OFF
-
WLAN unit is ON
SIM Card slot
(for Vega Wireless Camera GPRS)
INPUT clamp strip
STATUS
Image capture is
OFF
OFF
Blinking
Image capture is
ON
ON
-
Advertisement
Table of Contents
