Table of Contents
Advertisement
Main Menu
Table of Contents
SUPPORT ROD
3.
Pull the support rod out of its clip
and insert the end into the hole on
the driver's side of the hood.
To Close the Hood:
Lift it up slightly to remove the
support rod from the hole. Put the
support rod back into its holding clip.
Lower the hood to about a foot (30
cm) above the fender, then let it
drop. Make sure it is securely
latched.
Oil Check
Wait a few minutes after turning the
engine off before you check the oil.
1.
Remove the dipstick (orange
handle).
2.
Wipe off the dipstick with a clean
cloth or paper towel.
3.
Insert it all the way back in its hole.
Service Station Procedures
DIPSTICK
4.
Remove the dipstick again and
check the level. It should be
between the upper and lower
marks.
If it is near or below the lower mark,
see
Adding Oil
UPPER MARK
LOWER MARK
on page
211
.
171
Before Driving
Advertisement
Chapters
Table of Contents
