Cisco WAP121 Administration Manual page 75

Wireless Settings
Networks
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
• Key Length—The length of the key. Select one:
- 64 bits
- 128 bits
• Key Type—The key type. Select one:
- ASCII
- Hex
• WEP Keys—You can specify up to four WEP keys. In each text box, enter a
string of characters for each key. The keys you enter depend on the key
type selected:
- ASCII—Includes upper and lower case alphabetic letters, the numeric
digits, and special symbols such as @ and #.
- Hex—Includes digits 0 to 9 and the letters A to F.
Use the same number of characters for each key as specified in the
Characters Required field. These are the RC4 WEP keys shared with the
stations using the WAP device.
Each client station must be configured to use one of these same WEP keys
in the same slot as specified on the WAP device.
• Characters Required: The number of characters you enter into the WEP Key
fields is determined by the Key length and Key type you select. For
example, if you use 128-bit ASCII keys, you must enter 26 characters in the
WEP key. The number of characters required updates automatically based
on how you set Key Length and Key Type.
• 802.1X Authentication—The authentication algorithm defines the method
used to determine whether a client station is allowed to associate with WAP
device when static WEP is the security mode.
Specify the authentication algorithm you want to use by choosing one of
these options:
- Open System authentication allows any client station to associate with
the WAP device whether that client station has the correct WEP key or
not. This algorithm is also used in plaintext, IEEE 802. 1 X, and WPA
modes. When the authentication algorithm is set to Open System, any
client can associate with the WAP device.
5
75