General Information - Haier HRD-2714CS User Manual

REFRIGERATOR MAINTENANCE
Method of Replacing Supply cord:- If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Method of Replacing Lamp :- Switch Off the Refrigerator, then take out chiller tray.
Remove the faulty lamp & fit the new lamp with same wattage rating and type.
Place the chiller tray in its proper position & switch on the supply.
Remember: Disconnect the power supply before you start cleaning the refrigerator. - CLEANING
EXTERIOR
Use a soft cloth with warm water
and mild detergent. Do not use
a brush for cleaning.
INTERIOR
Wash the insides of the
compartments with a mild
detergent solution. Do not
use boiling water, gasoline
or benzene for cleaning.

GENERAL INFORMATION

VACATION TIME
During short vacations you
will probably find it best to
leave the refrigerator in
operation. Place eatables in
trie freezer for longer and
better preservation. During
an extended vacation,
remove all food, disconnect
the power cord,clean the
interior thoroughly and
leave the door slightly ajar
to prevent odour formation.
Note: Do not hold the refrigerator by its door and the piping of condenser-
That's dangerous!
KEEPING THE REFRIGERATOR FRESH
MAGNETIC DOOR
GASKET
Wash with mild detergent
solution using a soft cloth.
Make it a point to clean the
gasket at least twice a year.
Apply a thin layer of petroleum
jelly to keep it supple and pliable.
POWER FAILURE
Most power failures are
corrected in an hour or two
and will not affect your
refrigerator temperature.
However, you should
minimize the number of
door openings while the
power is OFF. During power
failures of longer duration,
place a block of dry Ice on
top of frozen packages.
6
-
VEGETABLE BOX
Excess water that accumulates
at the bottom of the vegetable
crisper should be emptied and
the crisper should be wiped dry.
WHILE SHIFTING THE
REFRIGERATOR
Unplug the refrigerator.
Take out the foods and dry
the water tray before
moving the refrigerator.
Remove or securely fasten
down all loose items inside
the refrigerator. To avoid
damaging the leveling
screws, turn them all the
way into the base.