Removing A Mezzanine Card; Installing A Mezzanine Card; Concluding Steps - Fujitsu Primergy BX920 S4 Upgrade And Maintenance Manual

Ê Remove the server blade from the system unit as described in section
"Removing the server blade from the system unit" on page
Ê Open the server blade as described in section
on page 56.
Ê Locate the defective mezzanine card using the onboard Local Diagnostic
LEDs as described in section
page 260.
7.1.4.3

Removing a mezzanine card

Ê Remove the defective mezzanine card as described in section
mezzanine card" on page
7.1.4.4

Installing a mezzanine card

Ê Install the new mezzanine card as described in section
mezzanine card" on page
7.1.4.5

Concluding steps

I
If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller
(expansion card or onboard CNA). For further information, please refer
to section "Note on network settings recovery" on page
Perform the following procedures to complete the task:
Ê Close the server blade as described in section
page 57.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page
Ê If applicable, close the rack door as described in section
door" on page
Ê Enable the PCI slot of the replaced mezzanine card as described in section
"Enabling replaced components in the system BIOS" on page
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 94.
BX920 S4
"Onboard indicators and controls" on
137.
131.
62.
"Looking up changed MAC / WWN addresses"
Upgrade and Maintenance Manual
Expansion cards and backup units
"Opening the server blade"
"Closing the server blade" on
55.
"Removing a
"Installing a
140.
58.
"Closing the rack
87.
141