D-Link AirPlus DWL-800AP+ Manual page 19

Troubleshooting
2. The wireless client cannot access the Internet in the Infrastructure
mode.
• Make sure the wireless client is associated and joined with the correct
device. To check this connection: Right-click on the Local Area
Connection icon in the taskbar> select View Available Wireless
Networks. The Connect to Wireless Network screen will appear.
Please make sure you have selected the correct available network, as
shown in the illustrations below.
• Check that the IP Address assigned to the wireless adapter is within
the same IP Address range as the existing network. Since the
DWL-800AP+ has an IP Address of 192.168.0.30, wireless adapters
must have an IP Address in the same range, e.g., 192.168.0.x. Each
device must have a unique IP Address; no two devices may have the
same IP Address. The subnet mask must be the same for all the
computers on the network.) To check the IP Address assigned to
the wireless adapter, double-click on the Local Area Connection
icon in the taskbar > select the Support tab and the IP Address will
be displayed. (Please refer to Checking the IP Address in the
Networking Basics section of this manual.)
• If it is necessary to assign a Static IP Address to the wireless
adapter, please refer to the appropriate section in Networking
Basics. If you are entering a DNS Server address you must also
enter the Default Gateway Address. (Remember that if you have a
DHCP-capable router, you will not need to assign a Static IP Address.
See Networking Basics: Assigning a Static IP Address.)
• If you are using the DWL-800AP+ to repeat the wireless signal, check
that the Ethernet MAC address of the wireless router or Access Point
is entered properly in the settings. Please note that the Repeater
function is compatible with most D-Link wireless routers and Access
Points. If you wish to repeat a device that is not a D-Link product,
please check the FAQs for supported products on the D-Link support
website (
can be repeated by the DWL-800AP+.
http://support.dlink.com ) to make certain that the device
Default