Installer Setup - Honeywell FocusPRO TH6110D Installation Manual

Installation Guide

Installer setup

Follow the procedure below to configure the thermostat to match the installed
heating/cooling system, and customize feature operation as desired.
To begin, press and hold the
buttons until the display changes
Setup Function
1 System type
2 Changeover valve
(O/B terminal)
3 Fan control
(heating)
5 Heating cycle rate
(CPH: cycles/hour)
9 Compressor
cycle rate (CPH)
12 System setting
adjustment
13 Adaptive Intelli-
gent Recovery
14 Temperature
display
15 Compressor
protection
16 Schedule format
and
F F A A N N
Settings & Options
0 Gas, oil or electric heat with air conditioning
1 Heat pump
2 Heat only (2-wire systems/power to open & close zone valves/
normally open zone valves)
3 Heat only with fan
4 Cool only
0 Changeover valve (O/B terminal energized in cooling)
1 Changeover valve (O/B terminal energized in heating)
0 Gas or oil furnace — equipment controls fan in heating
1 Electric furnace — thermostat controls fan in heating
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnaces
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
3 Recommended for most compressors
[Other cycle rate options: 1, 2, 4, 5 or 6 CPH]
0 Manual changeover (Heat/Cool/Off)
1 Auto changeover (Heat/Cool/Auto/Off)
2 Auto changeover only (Auto)
1 On **See page 10
™ 0 Off
0 Fahrenheit
1 Celsius
5 Five-minute compressor off time
[Other options: 0, 1, 2, 3 or 4-minute off time]
0 5/2 (programmable weekdays and weekends)
1 5/1/1 (weekdays, Saturday & Sunday programmable)
Function
number
1
Done
Press or
Press
N N E E X X T T
Press
D D O O N N E E
**See page 10
8
Setting
Next
to change settings
to advance to next function
to exit and save settings
**See page 10
**See page 10
0