Table of Contents
Advertisement
Remote Control of OSD from PC
Rev 1.00
3.
Unpack the zip file into an appropriate folder.
Double-click the Setup.exe file to launch the Setup Program.
4.
5.
Ensure that the COM port you connected the RS485 converter to is selected. See the
figure below.
6.
Click OK to initialize Communication (this can take up to 20 seconds).
7.
If Communication failed you can:
a.
Check the wiring and power connections of the camera, or
b.
Click Retry to initialize Communication again, or click End to close the window.
8.
If Communication is successful, the following window will appear. See the next
sections for remotely controlling your HCC484TP Camera.
2
D002529
04/06
Advertisement
Table of Contents
