Get Started; Connect The Base Station; Install The Handset - Philips S10 User Manual

3 Get started

Caution
•
Make sure that you have read the safety instructions in
the 'Important safety instructions' section before you
connect and install your handset.

Connect the base station

Warning
•
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back or underside of the phone.
•
Use only the supplied power adapter to charge the
batteries.
Note
•
If you subscribe to the digital subscriber line (DSL)
high speed internet service through your telephone
line, ensure you install a DSL filter between the
telephone line cord and the power socket. The filter
prevents noise and caller ID problems caused by DSL
interference. For further information on DSL filters,
contact your DSL service provider.
•
The type plate is located on the bottom of the base
station.
1
Connect the power adapter to:
• the DC input jack at the bottom of the
base station;
• the power socket on the wall.
2
Connect the line cord to:
• the telephone socket at the bottom of
the base station;
• the telephone socket on the wall.
EN
6
3
Connect the power adapter to (for extra
handset versions only):
• the DC input jack at the back of the
extra handset charger.
• the power socket on the wall.

Install the handset

Your handset comes with a high quality Lithium
Ion Polymer battery to maximize battery
lifetime. However, over time the capacity
of the battery will decrease. You can order