Hitachi 27GX01B-501 Service Manual page 11

Using the Remote to Control VCR and Cable box Funtions
Operating the
Function for Your VCR
This remote is designed to operate
different types of VCRs. You must first
program the remote to match the
remote system in your VCR. (Refer to
the VCR Code Index section.)
1. Turn on your VCR.
2. Aim the remote control at the front
of your VCR.
3. Press the VCR button to switch to
VCR precoded mode.
4. While holding down the VCR
button, enter the 2-digit preset
code that matches your VCR*.
The remote will turn on your VCR
when the correct 2-digit preset
code is entered. When this occurs,
the remote control is programmed
for your VCR. If your VCR does
not turn off after 5 seconds, try a
different 2-digit preset code.
5. The remote will now control your
VCR.
NOTES:
• If your VCR cannot be operated
after performing
procedures, this means that your
VCR codes have
precoded into the remote.
• In the unlikely event that your VCR
cannot be operated
performing the above procedures,
consult your VCR operating guide.
• The remote control will remember
the codes you have programmed
in until the batteries are removed.
After replacing the batteries repeat
the entire programming procedure
stated above.
• If your VCR does not have a
power function, the remote will
issue the CHANNEL UP function.
Precoded
POWER
1
4
7
MUTE
INPUT
MENU
RECALL
REC
TV/VCR
the above
not been
after
* (Codes are listed on page 12)
TV CABLE VCR
2 3
CH
5 6
CH
8 9
VOL
0
LST-CH VOL
SLEEP
CURSOR
CONTROL
STOP
PAUSE
tt t uu
HITACHI
CLU-351U
- 11 -
Operating the
Function for Your Cable Box
1. Turn on your cable box.
2. Aim the remote control at the front
of your cable box.
3. Press the cable box button to
switch to cable box precoded
mode.
4. While holding down the CABLE
button, enter the 2-digit preset
code that matches your cable
box*. The remote will turn on your
cable box when the correct 2-digit
preset code is entered. When this
occurs, the remote control is
programmed for your cable box. If
your cable box does not turn off
after 5 seconds, try a different 2-
digit preset code.
5. The remote will now control your
cable box.
NOTES:
• If your cable box cannot be
operated after performing the
above procedures, this means that
your cable box codes have not
been precoded into the remote.
• In the unlikely event that your
cable box cannot be operated
after performing
procedures, consult your cable
box operating guide.
• The remote control will remember
the codes you have programmed
in until the batteries are removed.
After replacing the batteries repeat
the entire programming procedure
stated above.
• If your cable box does not have a
power function, the remote will
issue the CHANNEL UP function.
• For some models, the remote
control's channel
control the cable box channel. The
number buttons will control your
television channel although you
are in cable mode.
Precoded
the above
and will