General Information - Sharp KB-6024MS Service Manual

Microwave drawer

Operation manual (24 pages)

Installation tips (2 pages)

Operation manual (24 pages)

Table of Contents

This oven is equipped with a three prong grounding plug. It must be plugged into a wall receptacle that is properly installed

and grounded in accordance with the National Electrical Code and local codes and ordinances.

In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the

electric current.

WARNING:

Improper use of the grounding plug can result in a risk of electric shock.

Electrical Requirements

The electrical requirements are a 20 volt 60 Hz, AC only, 5 or 20 amp. fused electrical supply. It is recommended that a

separate circuit serving only this appliance be provided. When installing this appliance, observe all applicable codes and

ordinances.

Where a two-pronged wall-receptacle is encountered, it is the personal responsibility and obligation of the customer to con-

tact a qualified electrician and have it replaced with a properly grounded three-pronged wall receptacle or have a grounding

adapter properly grounded and polarized. If an extension cord must be used, it should be a 3-wire, 5 amp. or higher rated

cord. Do not drape over a counter top or table where it can be pulled on by children or tripped over accidentally.

CAUTION: DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE ROUND GROUNDING PRONG FROM

THIS PLUG.

NOTE:

The directed features are disabled after one minute when the oven is not in use. These features are automatically enabled

when the door is opened and closed or the STOP/ CLEAR pad is pressed.