Unpacking; Removing Protective Packing Materials; Developer Unit Installation - Sharp AR-168S Service Manual

4. Unpacking

Be sure to hold the handles on both sides of the machine to unpack the
machine and carry it to the installation location.

5. Removing protective packing materials

1) Remove all pieces of tape shown in the illustration below and then
open the SPF/RSPF and remove the protective materials. Take out
the bag containing the toner cartridge.
2) Release the scan head locking switch.
Grasp here and turn in
the direction of the arrow.
Lock Unlock
3) Open the bypass tray, and then open the side cover while pressing
the side cover open button.
AR-168S/168D UNPACKING AND INSTALLATION 5 - 2
4) Remove the CAUTION tape from the front cover and remove the
two protective pins from the fusing machine by pulling the strings
upward one at a time.
CAUTION tape

6. Developer unit installation

1) 2) 3) Open the side and front cabinets of the copier.
4) Remove the locking tape of the developer unit.
5) Remove the screw which is fixing the copier and Developer unit.
6) Remove Developer unit slowly from the copier.
5
3
4
7) Remove the screw (1 pc).
8) Remove Upper developer unit.
Protective pins
2
1