Adjusting The Presser Foot Height - Brother S-7000DD Instruction Manual

7. STANDARD ADJUSTMENTS

7-2. Adjusting the presser foot height

29
The standard height of the presser foot (1) is 6 mm when the
presser foot (1) is raised by means of the lifting lever (2).
1. Loosen the nut (3) of the adjustment screw (4), and then
turn the adjustment screw (4) so that there is no pressure
applied to the presser foot.
2. Raise the lifting lever (2). The presser foot (1) will also
rise.
3. Remove the oil cap (5).
4. Loosen the bolt (6) and then move the presser bar (7) up
or down until the presser foot (1) is at the standard height
of 6 mm.
5. Tighten the bolt (6).
6. Replace the oil cap (5).
7. Adjust the presser foot pressure using the adjustment
screw (4), and then tighten the nut (3).
NOTE:
Needle
0534D
S-7000DD
After adjusting, check that the needle moves down into
the center of the groove in the presser foot.