Gear Case Lubrication - Honda HHE31C Owner's Manual

SERVICING YOUR HONDA STICK EDGER
Insert the tip of the 3/16" (5 mm) hex wrench
(commercially available) fully into the hole to
lock the blade into position.
SPLIT PIN
10 mm NUT
OUTER BLADE HOLDER A
4. Remove the 10 mm nut (in a clockwise
rotation) and outer blade holder A from the
end of the shaft. Remove the blade, making
sure the inner blade holder B remains on the
shaft.
5. Install and center the blade on the inner
blade holder B. Install the outer blade holder
A. Install the nut (counterclockwise) using a
torque wrench to tighten the blade nut to a
torque of 19.2~22.1 ft-lb (26~30 N•m).
6. Install a new split pin to secure the blade
nut.
7. Connect the spark plug cap.
28

Gear Case Lubrication

1. Move the ignition switch to the OFF (0)
position and disconnect the spark plug cap.
HOLE
INNER
BLADE
HOLDER B
(remains
on shaft)
2. Remove the 8 x 10 mm bolt from the
gear case.
3. Fill the gear case with NLGI No. 2 grease
until it runs out from the bolt hole.
4. Install the 8 x 10 mm bolt in the gear case
and tighten securely.
8 x 10 mm BOLT
GEAR CASE